I have checked the FAQs about this and still have questions. I am trying to clear the turn signals on my 2k. I sat there with a hair dryer for a while with no results. Next, I tried the oven method, but the oven seems too small. The headlight comes really close to hitting the heating element and i dont want to melt the plastic.

Anybody have any other ideas on how to melt the sealant? Any tips on how/where to start prying the lens off?

Thank you for reading another post about lens clearing.

heat gun. hair dryer just isnt hot enough oven is to small heat gun should be good it gets really hot

but than again i could be wrong but at this point u dont really hav any other options so i think its worth a try

Thanks for the reply. I actually got them to fit in the oven. Turns out I was trying to stuff them in the toaster, Im lost in the kitchen

Anyhoo, They are done and look great.

BTW: Anyone else doing this on the 2k-2k1 Halogens. There is a screw holding the orange lens on, so dont try to break it off like it says in the how to (that is for the HIDs).