http://www.flickr.com/photos/113675646@N06/11873583163/http://www.flickr.com/photos/113675646@N06/11873584503/
97 Maxima in Virginia – $2500 for everything below minus the stuff listed at the bottom. If this doesnt sell Im parting it out.

The good:

• Koni Yellows (front strut shortened an inch)
• Progress Springs and an extra set of Eibachs
• Progress Rear sway bar
• Rear beam is bent to zero toe for better handling
• Subframe connectors welded on.
• 3” Catman Catback with Fast cat converter
• Front and rear strut bar
• 00vi conversion
• Interior is in excellent shape for age/mileage of car.
• Black on Black.
• Tinted windows
• Blemco Stage 2 lower frame stiffener
• ES bushing, Whiteline bushings (increases caster in the front), Delrin lower control arm bushings)
• HID headlights with TL projectors and upgraded lenses.
• 01 SE VLSD Tranny
• Fidanza Lightened flywheel

The bad: 3.0 Engine has 230k on it and has a bad dead spot (I think it’s a coil pack or injector). It also loses about a quart of oil every 4k miles. I would suggest dropping a new engine in it. (see below). It still runs just fine enought to reliabily get you rfrom a to b so you can drive this home.
Steering rack needs to be replaced along with the steering rack rubber brackets.

Extra parts (not included with sale of car but are complete):

• VQ35 engine with 65k on it - $500
• Catman Gen 2 headers - $500
• Kevlo LED light boards - $300
• Complete wiring harness and all associated parts for full swap. This includes: dash gauges, pedal, ignition switch, ECU, custom timing ring for 5speed tranny, extra ECU brackets, Engine harness, and NEARLY completed conversion harness (see the attached thread). The only piece I have not completed of the conversion harness is the power portion of the harness…everything else is complete and I just don’t have the time to finish the project. http://forums.maxima.org/all-motor/6...p-harness.html - $500

 

Glws, just pmed you

 

Thanks. I got your PM. Give me a call.

 

Man if i was closer id probably buy this and swap a new engine in. Basically everything i want in a max..

GLWS and worst comes to worst me and others will eat up those parts like candy

 

U never posted how far u got on the swap harness.more info on that please.

 

Do you still have the VQ35 for sale?

 

what happened to your project?

 

I just didn't have time to finish it but the harness is nearly complete. The only part that has to be worked out is the 12v power portion and I'm selling everything to one lucky forum member that wants to by all my full swap parts. $300 plus shipping.