Ok, i just finished putting my factory springs on and my springs still pop when i turn the wheel!! i read the post about the rubber thingy at the top between the spring and the plate that bolts to the uhh..... thingy at the top of the wheel well. yeah, that piece was on there... i'm clueless. help. please. i'll do it!! I'LL BUY A HONDA!!! DON'T PUSH ME!!

anyway, please help... i'm tired of all this.

Ben

 

pop? Im assuming that your strut bearings need to be lubed or replaced.

 

Wait for them to settle. It'll go away.

 

When the AGX and H&Rs were installed, there was a slight popping/knocking noise from the front end when steering, but it has since gone away.

 

Was the word OUT facing outwards on the upper spring perch?

 

i got the strut bearings and put em' on but it still pops. not as bad but it does...

Ben

 

Something isn't right with the install of the OE springs. They should be silent!

As I mentioned before, make sure the word OUT faces out on the upper spring perch. If it's not correct, your spring will not be seated correctly.

Also the OEM springs have a top and bottom, are yours in upside down?
I believe there are 3 painted dots. They should be positioned like a triangle. The single dot above the 2 dots. If the 2 dots are above the 1 dot, your springs are upside down.

 

ok, it turned out to be my strut bearing. i didn't have one on there at all!!! thanks for everyones help tho

Ben

 

heheheh i knew it

 

 

 

Ok, the strut bearing stoped the popping for about a week but now the right one pops again!! WTF?!?

Ben

 

did u replace both strut bearings or just one?

 

Just one

 

buy a honda lol j/king

 

i was actually thinking about a MR2 but i doubt it'll happen...

Ben

 

just as a side note here you spell it suspension not suspention. I assume u didnt get search results becasue of it. Glad problem was solved tho

 

That would solve a lot of problems wouldn't it?? I guess thats why people go to cah-leh-ge

Ben