When you sprayed down the butterfly, is it possible to use too much carb cleaner? The car won't start. Did I hydro locked it? I opened up the butterfly valve and sparyed some into the manifold too.

 

i hope you didn't use carb cleaner.. and you used TB cleaner for Fuel Injected Engines

 

I used carb cleaner....so what should I do now?

 

give it some time to dry out... that would be my guess for now.. maybe matt might have a better idea

 

Hold the throttle wide open when you crank it. (foot on the floor) It will start and throw out some nasty smoke. Might run a bit rough for a minute or two as well.

 

No need to worry about hydro-locking - unless you used about 1.5 litres of carb cleaner.

 

you should be fine. just start the car like the engine was flooded...like Tom said.

 

if it won't turn over at all, wait a few minutes and see if some of it evaporates. if not, then pull out the spark plugs, stick some rags/paper towels over the holes, and crank it over then. oughta blow the junk out, then put the plugs back in and drive away.