Is APC wire harness any good? And how hard is it to install? Also have any of you had any problems with it?

 

any good?...better than frying your stock harness...

hard to install? no...go to www.maximadriver.com and go to the "How2" section...there is a diagram of how to install it..

problems? yes...a few of us have gotten kits with bad relays...no biggie though...just send it back and get a new one..

 

i didn't notice any difference in light, but i like the assurance it's not going to burn out my stock wiring anytime soon.

 

Where can you buy these at??? I have been looking for them and I am having a hard time finding them.. Does anyone here have one that they are wanting to sell?
Thanks
BIGDOG

 

Goto www.autodynamics.com.....The have a model for 9004 systems..

 

the carshow relays right? i just cut them out and replaced them w/ a B&P and Bosch relays. 40A and 30A.

 

Maybe there's something up with my car but I am on my second wire hareness. The first one burned and the relays were bad, so I sent that one back and got another one. The new one got a little bit burned and my right headlight is dimmer then my left, I guess it's just some loose wiring or something. So my experience with the APC wire harness is not a good one.
As far as the install, it's a piece of cake. Very easy.

 

you got it...i gotta do it again actually...lows are gone...hehe

 

well sell me your broken harnesses w/ the dead relays! i say umm...10 bucks?

 

Pardon my complete ignorance, but why do you guys have this harness? What does it do?

 

when running higher wattage headlight bulbs the very thin stock wires and socket have a tendency to melt/over heat.
the upgraded harness have thicker wire that can sustain higher wattage and heat w/o melting.