just got a new 5th gen clutch in with MT90 and a steel clutchline. Bled the system and checked everything. Pedal has no resistance until the last inch before it hits the floor. Thinking its one of the cylinders or maybe both. Any ideas? cheapest place to get either of them?

 

If the hydrolic system was working before the clutch install I would guess you have not bled it correctly. Pretty small chance that it happen to go bad at the exact time a clutch job was done. It has taken me hours to completely bleed my clutch before

 

does your slave cyl move while you press the clutch?

 

im not sure. no one's around to help me but i'll look into it. what if it does move?

 

what's your bleeding procedure, since you're doing it alone? and did you use brake fluid that had been opened b4? fluid absorbs moisture, over time it can be useless.