4th Generation Maxima (1995-1999) Visit the 4th Generation forum to ask specific questions or find out more about the 4th Generation Maxima.

How The F**K DO I Change My Rear BumPer?!?!?

Thread Tools
 
Search this Thread
 
Old Sep 9, 2006 | 01:48 AM
  #1  
The Russian's Avatar
Thread Starter
Senior Member
iTrader: (4)
 
Joined: Oct 2004
Posts: 1,198
From: Russia
How The F**K DO I Change My Rear BumPer?!?!?

so my bumper now is all ****ed up so i got a new one, and its already painted and all, i just need to put it on, how hte hell do i do that? i dont want to mess somthing up =/ HELP ORGERS!!!
Old Sep 9, 2006 | 03:03 AM
  #2  
PARALLEX's Avatar
Supporting Maxima.org Member
 
Joined: Aug 2004
Posts: 337
i take it u havent looked in a haynes repair manual yet huh??? check under body section it has step by step instructions...
Old Sep 9, 2006 | 04:23 AM
  #3  
njmaxseltd's Avatar
Member who somehow became The President of The SE-L Club
iTrader: (19)
 
Joined: Jun 2001
Posts: 16,024
Take out a few clips and screws from the bottom. I think there are a few that go across the rear and one or two right in back of the rear wheel.
Then fron inside the trunk you need to remove a few bolts holding the cover to the chassis. There are 2 in the lower corners inside the trunk. Pull the trunk lining out to get down into the corners. One bolt sits forward and one sits right in the corner. All are 10mm. Should take you no more then 15 - 20 min. to get the cover off. Look at the new part you have to see where most of the bolt/screw/clip locations are, then find them on your car.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
vingodine
5th Generation Classifieds (2000-2003)
45
May 21, 2016 12:46 PM
JoshG
4th Generation Maxima (1995-1999)
21
Sep 4, 2015 09:04 PM
steven4838
7th Generation Maxima (2009-2015)
0
Aug 26, 2015 11:04 AM
laflyer23
5th Generation Classifieds (2000-2003)
0
Aug 22, 2015 10:04 PM
maxipower
5th Generation Maxima (2000-2003)
2
Aug 21, 2015 11:10 AM




All times are GMT -7. The time now is 06:09 AM.