Throw out bearing or input shaft bearing noise? Which is it?
Throw out bearing or input shaft bearing noise? Which is it?
Recently I've noticed that I'm getting a noise from my tranny. At first I thought it was my TO bearing, but after talking to some people, it sounds like it may be the input shaft bearing going bad.
If the car is in neutral, I get a slight chattering, but when I push on the clutch the noise goes away. From what I understand, this is the opposite of what happens when your TO bearing goes bad. Can anybody verify this?
The tranny is a rebuilt unit from Phoenix Reman. Trannies I bought on Ebay 3 years ago. The TO bearing is a OEM unit I had installed with my Spec stage 2 about a year or two ago. I've heard of people who buy reman trannies and the shafts aren't shimmed properly, so after 15,000-20,000 miles, the input shaft goes bad. Since I've put on about 20,000 miles on this tranny, it makes me wonder if this really is my problem.
Any tips or advice would be appreciated. Thanks.
If the car is in neutral, I get a slight chattering, but when I push on the clutch the noise goes away. From what I understand, this is the opposite of what happens when your TO bearing goes bad. Can anybody verify this?
The tranny is a rebuilt unit from Phoenix Reman. Trannies I bought on Ebay 3 years ago. The TO bearing is a OEM unit I had installed with my Spec stage 2 about a year or two ago. I've heard of people who buy reman trannies and the shafts aren't shimmed properly, so after 15,000-20,000 miles, the input shaft goes bad. Since I've put on about 20,000 miles on this tranny, it makes me wonder if this really is my problem.
Any tips or advice would be appreciated. Thanks.
nealoc187 can help you sounds like input shaft bearing, i have the same thing and i have the exedy stage 1 clutch, push the clutch in while in the neutral car is silent, release and i hear this hissing kinda spinning noise? hope i can make it through another drag racing season?
links
http://www.motorvate.ca/mvp.php/801
http://forums.maxima.org/showthread....58751&t=473007
http://forums.maxima.org/showthread.php?t=432379
links
http://www.motorvate.ca/mvp.php/801
http://forums.maxima.org/showthread....58751&t=473007
http://forums.maxima.org/showthread.php?t=432379
Originally Posted by 95maxrider
anybody else?
It's definitely the input shaft bearing. Make sure whoever replaces it reshims the tranny correctly, or else it's going to fail again on you prematurely.
Originally Posted by machiniac_g
it is the T.O. bearing which is causing your noise .if it was the shaft bearing then you would have atarns failure a long time ago
Don't listen to this guy because he doesn't know what he's talking about.
edit: looks like you found my thread 95maxrider, good. hopefully it will help others too.
Originally Posted by Nealoc187
Don't listen to this guy because he doesn't know what he's talking about.
edit: looks like you found my thread 95maxrider, good. hopefully it will help others too.
edit: looks like you found my thread 95maxrider, good. hopefully it will help others too.
Thread
Thread Starter
Forum
Replies
Last Post
litch
4th Generation Maxima (1995-1999)
123
Jan 4, 2024 07:01 PM
My Coffee
New Member Introductions
15
Jun 6, 2017 02:01 PM
Andy29
5th Generation Maxima (2000-2003)
8
Sep 29, 2015 05:32 AM





