I have Timken front bearings want to replace with the axles whats the best synthetic grease should be used for them or sealer.

Regards,

Mike

 

exactly where would you be using grease when replacing your bearings? From what i remember no grease was required on this job...

 

Bearings should be sealed on each side and if they are not sealed I would not use them.

 

Exact Picture of the bearing.

 

Does this needs seal or grease and which one.

Thanks.

 

No external seal needed the bearing is a sealed unit(no roller bearings exposed, sealed on each side). Do not remove a seal and try to add more grease.

 

indeed - if you plan on opening the bearing, you better order two because that one will be useless.

Our bearings are pressed in. If you're trying to push the sucker in, a lack of grease isn't yoru solution.. a 2 tonne press is

 

Just press it in... correctly and call it the day! Or if you're not happy with those bearings, take the p/n and go buy a higher quality bearing from a local bearing supply that may by serviced with synthetic grease! How do you know these aren't filled with synthetic grease?