Hello, Im looking for a Dayco Idler pulley for a supercharger setup. If anyone has one for sale or knows where I can get a pulley or just bearings for that matter it would be greatly appreciated!

Thanks

 

V1 or V2 plate?

 

If you have a V1, I sell Fenner Idler pulleys. The one that Stillen included in the original kits.

I used a Dayco for a few months. The side rails arent that big that the pulley made bit of noise

-matt

 

its a V1 plate but it has a Dayco idler pulley on it. I bought the kit from Kenneth who got it from Craig Mack (I know throw back!). Stephenmax modified the plate (I believe read it in an old post) to use the V2 Dayco pulley on the V1 plate. Do you guys think I would have a problem running a Fenner? Are they the same dimensions?

Matty, how much for the pulley?

 

D@MN, Kenneths old V1, have you had it rebuilt yet?
You can use the Fenner, but use the bolt that Matty supplies.
I have Stephens old V1 plate and it had the Dayco pulley as well. Im now running the Fenner pulley from Matty.

 

yeah its Kenneths old set up...Ive had it for about 4 or 5 years by now! No rebuild yet for me, the shaft has zero play and there are no visible leaks on the seals so its good to go.

Does Mattys pulleys come with the washers too? How will I know which washer goes on each side of the pulley? I'm assuming the fenner is different than the dayco pulley.

Matty I'm sending you a PM

thanks!

 

Comes with the spacer and bolt.
No rebuild huh? That thing was crazy loud, much louder then my V1 and we always just assumed it needed a rebuild. The whole time he ran it I dont think he used a filter on it.

 

awesome, nice to know 5 years after the fact lol

 

Jason,
if its the pulley with the rails that you need I have the one that came with the stillen kit. Don't know the brand because I cannot see it right now, but I know I have it at home.

 

damn Carson, I paypaled Matt on Friday for the pulley. I thought I read somewhere that you had an extra one laying around too.