1/4 and 1/8 Mile Racing Talk about track times, launch techniques, strategies, etc. Check out the "Timeslips" subforum for posted times.No discussion of street racing will be tolerated.

So i went to the 1/4 mile finally

Thread Tools
 
Search this Thread
 
Old Oct 25, 2010 | 09:22 AM
  #1  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
So i went to the 1/4 mile finally

i ran out of time and had to leave cause i had to go else where ...


But i felt like crying again this is a 04 nissan maxima 5 speed auto



IM GOING AGAIN the next time the track is open is on friday !

Old Oct 25, 2010 | 11:32 AM
  #2  
NmexMAX's Avatar
dot dot dot ...
iTrader: (22)
 
Joined: Dec 2000
Posts: 34,576
From: Santa Fe, NM
Not bad at all. Especially if you don't have any mods ... So, do you have any mods?
Old Oct 25, 2010 | 11:38 AM
  #3  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
Full boltons

no tune however
Old Oct 25, 2010 | 11:45 AM
  #4  
NmexMAX's Avatar
dot dot dot ...
iTrader: (22)
 
Joined: Dec 2000
Posts: 34,576
From: Santa Fe, NM
Headers?

What were the weather conditions (DA) and at what track was this at?
Old Oct 25, 2010 | 12:09 PM
  #5  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
ok my DA for that time was a 2200

thank you for bringing the DA to my attention

ima hope for better next time and do my research !
Old Oct 25, 2010 | 12:38 PM
  #6  
NmexMAX's Avatar
dot dot dot ...
iTrader: (22)
 
Joined: Dec 2000
Posts: 34,576
From: Santa Fe, NM
Could you leave a sorta detailed list of mods you have?
Old Oct 25, 2010 | 12:38 PM
  #7  
1sik4dsc's Avatar
Senior Member
iTrader: (1)
 
Joined: Jun 2009
Posts: 1,204
From: NY
those arent bad times at all, alil more practice and alil bit of luck you should be in the 13s
Old Oct 25, 2010 | 01:02 PM
  #8  
krazy6's Avatar
Senior Member
iTrader: (5)
 
Joined: May 2005
Posts: 1,565
From: Yorba Linda, CA
Try to get some drag radials for the front. Should make a noticeable difference.

60ft is pretty decent for street tires though. Good job.

The MPH seems pretty low though.
Old Oct 25, 2010 | 09:43 PM
  #9  
tedo007's Avatar
faster than you think
iTrader: (6)
 
Joined: Jun 2004
Posts: 1,765
From: Eufaula, AL
Jealous of the numbers.. Nice!
Old Oct 26, 2010 | 04:14 AM
  #10  
Grand_hustle17's Avatar
Senior Member
iTrader: (22)
 
Joined: Dec 2006
Posts: 7,825
......................... good numbers, just a little on the mod list would be nice
Old Oct 26, 2010 | 04:18 AM
  #11  
Grand_hustle17's Avatar
Senior Member
iTrader: (22)
 
Joined: Dec 2006
Posts: 7,825
Originally Posted by krazy6
Try to get some drag radials for the front. Should make a noticeable difference.

60ft is pretty decent for street tires though. Good job.

The MPH seems pretty low though.
Mph is about right..
Old Oct 26, 2010 | 08:26 AM
  #12  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
Racingline Highflow Precats
NWP block off plate
NWP IM spacers
Ralco Underdrive Pulley
Short Ram intake
Cat back Exhaust
Racingline y pipe
NGK 1 step colder
Ported Elbow
Old Oct 26, 2010 | 09:53 AM
  #13  
2002AltimateV6's Avatar
Senior Member
iTrader: (7)
 
Joined: Aug 2005
Posts: 547
From: Tacoma, WA
Not bad at all. With a better DA you will probably be in the 100+MPH range with a chance to hit 13s with traction.
Old Oct 26, 2010 | 10:37 AM
  #14  
ajcool2's Avatar
Senior Member
iTrader: (43)
 
Joined: May 2004
Posts: 10,550
From: Baltimore, Md
Nice times man.
Old Oct 28, 2010 | 12:33 AM
  #15  
aackshun's Avatar
Senior Member
iTrader: (3)
 
Joined: Aug 2007
Posts: 5,398
From: Houston, TX


Finally that car is performing!!! I remember the good ol malfunctioning KS days....
Old Oct 28, 2010 | 03:28 PM
  #16  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
oh god please don't mention those days lol !





So tomorrow i plan on going back to the track

i have 4 hours at the track to break 13's

and im not leaving until i break it .. or they force me out lol ...
Old Oct 28, 2010 | 03:51 PM
  #17  
MIKERNM1990's Avatar
Senior Member
 
Joined: Jul 2009
Posts: 424
any mod list?
Old Oct 28, 2010 | 04:21 PM
  #18  
krazy6's Avatar
Senior Member
iTrader: (5)
 
Joined: May 2005
Posts: 1,565
From: Yorba Linda, CA
Originally Posted by MIKERNM1990
any mod list?
Originally Posted by taz394
Racingline Highflow Precats
NWP block off plate
NWP IM spacers
Ralco Underdrive Pulley
Short Ram intake
Cat back Exhaust
Racingline y pipe
NGK 1 step colder
Ported Elbow
You need to learn how to read the whole thread. lol
Old Oct 28, 2010 | 04:27 PM
  #19  
321VQ35MAX's Avatar
Senior Member
iTrader: (6)
 
Joined: Feb 2008
Posts: 10,436
From: Sanford, FL
Originally Posted by MIKERNM1990
any mod list?





Congrats. I would love those times. But I think a 13 sec pass is there.. Nice 60 foot times..
Old Oct 28, 2010 | 06:01 PM
  #20  
krazy6's Avatar
Senior Member
iTrader: (5)
 
Joined: May 2005
Posts: 1,565
From: Yorba Linda, CA
Originally Posted by 321VQ35MAX
Congrats. I would love those times.
You could have those times.

Get some slicks and with some practice you could run a 13 second pass.
Old Oct 29, 2010 | 09:37 AM
  #21  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
8 hours until i get off and go to the track again

the DA tonight is going to be abt 1500 (unless the weather forcast screws up)

when i ran those times it was like 2150-2200

Last edited by taz394; Oct 29, 2010 at 11:25 AM.
Old Oct 29, 2010 | 11:11 AM
  #22  
krazy6's Avatar
Senior Member
iTrader: (5)
 
Joined: May 2005
Posts: 1,565
From: Yorba Linda, CA
Good luck man!
Old Oct 29, 2010 | 11:50 AM
  #23  
MIKERNM1990's Avatar
Senior Member
 
Joined: Jul 2009
Posts: 424
make sure about tire pressure have to low, its will make more improve traction via slip have been limit, so also weather degree is low, make sure about your car have heavy weight then get remove on passenger seat, back seat, gutted trunk, put ice in intake manifold for about 2hrs, i hope you will break 13 sec
Old Oct 31, 2010 | 11:04 AM
  #24  
Rods03Max619's Avatar
Senior Member
iTrader: (5)
 
Joined: Oct 2009
Posts: 8,946
From: Diego,California
Nice times!!
Old Apr 24, 2011 | 11:19 PM
  #25  
Ceasars Chariot's Avatar
Old Maxima Legend
iTrader: (16)
 
Joined: Apr 2003
Posts: 6,058
From: Paraparaumu, NZ
mighty good times ! thumbs up !
Old Apr 25, 2011 | 06:23 AM
  #26  
Grand_hustle17's Avatar
Senior Member
iTrader: (22)
 
Joined: Dec 2006
Posts: 7,825
nice... about a high 13's with better 60', however those are some good 60' times... keep at it
Old May 8, 2011 | 01:50 PM
  #27  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
its far from what it was lol

im running a bigshot of nitrous now with a whole lot of new mods (pretty much not a single mod left anymore for me to do)

saving up for a built transmission ... blowin tranny's left and right

and then that out the way the last step is the motor ... and then im moving on to a diff car

Last edited by taz394; May 8, 2011 at 02:13 PM.
Old May 8, 2011 | 02:11 PM
  #28  
krazy6's Avatar
Senior Member
iTrader: (5)
 
Joined: May 2005
Posts: 1,565
From: Yorba Linda, CA
Originally Posted by taz394
its far from what it was lol

im running a bigshot of nitrous now with a whole lot of new mods

saving up for a built transmission ... blowin tranny's left and right
What do you consider a big shot of nitrous?
Old May 8, 2011 | 02:15 PM
  #29  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
150 until i get a built tranny ... then im going direct port or maybe switching to 6an

btw i did get done with my car and blew it up again 2 days later LOL

so now im going for that built tranny


should've saved that time and took it to the track .. but the highways of mexico were calling me
Old May 8, 2011 | 08:32 PM
  #30  
krazy6's Avatar
Senior Member
iTrader: (5)
 
Joined: May 2005
Posts: 1,565
From: Yorba Linda, CA
Originally Posted by taz394
150 until i get a built tranny ... then im going direct port or maybe switching to 6an

btw i did get done with my car and blew it up again 2 days later LOL

so now im going for that built tranny


should've saved that time and took it to the track .. but the highways of mexico were calling me
150 is a good sized shot.
That's what I want to spray on my car when I eventually get a clutch in the car.

How much is a built tranny?
Old May 9, 2011 | 09:54 AM
  #31  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
$3600

btw i have an extra pair of aluminum 6 speed motor mounts if you would be interested

made a very big difference on my car from a dig
Old May 9, 2011 | 09:50 PM
  #32  
krazy6's Avatar
Senior Member
iTrader: (5)
 
Joined: May 2005
Posts: 1,565
From: Yorba Linda, CA
Originally Posted by taz394
$3600

btw i have an extra pair of aluminum 6 speed motor mounts if you would be interested

made a very big difference on my car from a dig
Damn, that's expensive. lol

No thanks on the mounts, don't have any money right now.
Old May 12, 2011 | 06:47 PM
  #33  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
alright well lemme know if you ever need em them just liein in the garage

they make a huge difference at each shift
Old May 18, 2011 | 09:53 AM
  #34  
Payu's Avatar
Member
 
Joined: Feb 2010
Posts: 29
How much WHP this car have?
Also any kind of weight reduction on these runs?
Old May 26, 2011 | 09:54 AM
  #35  
taz394's Avatar
Thread Starter
Senior Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 638
From: Houston,TX
i lost track with the mods and never got the car dyno'ed

this was all motor .. i have no clue
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
hez8813
5th Generation Maxima (2000-2003)
11
Mar 12, 2020 12:06 AM
markevans999
3rd Generation Maxima (1989-1994)
8
Oct 25, 2015 08:27 AM
LtLeary
7th Generation Maxima (2009-2015)
16
Sep 14, 2015 12:33 PM
hntwhttail
4th Generation Maxima (1995-1999)
0
Sep 12, 2015 03:43 PM
ag90fox
7th Generation Maxima (2009-2015)
6
Sep 9, 2015 12:22 PM




All times are GMT -7. The time now is 09:01 AM.