CEL on, but "no failure detected" when diagnosed
CEL on, but "no failure detected" when diagnosed
Hey guys i have the CEL on, and when i check for codes manually, i get 5 long pulses followed by 5 short pulses. When i diagnose it on the ecu decoder on vbxmaxima it says "No failure recorded/detected". Whats going on? is the decoder messed? Also, another time i checked i got 2 long pules and 15 short pulses, when i diagnosed that, it says "undefined". However, i got that code only once and now i just keep getting the 5 long pulses followed by 5 short ones.... what the hell is going on?
I once had that undefined code (0215) but it came with a knock sensor and evap canister control valve code too..
Knowing a knock sensor does not trigger the cel i fixed the evap canister control valve with some wd40 and the cel went away!
My knock sensor was actually bad tho .. so in my case it wasnt a ghost code.. I swapped the knock sensor and the harness and cleared all codes and that was it!
Try clearing the cel and see if it crops back up with anything else besides the "No failure recorded/detected" & "undefined".
(i used the manual way too i didnt have a scanner)
Knowing a knock sensor does not trigger the cel i fixed the evap canister control valve with some wd40 and the cel went away!
My knock sensor was actually bad tho .. so in my case it wasnt a ghost code.. I swapped the knock sensor and the harness and cleared all codes and that was it!
Try clearing the cel and see if it crops back up with anything else besides the "No failure recorded/detected" & "undefined".
(i used the manual way too i didnt have a scanner)
Yep, 0807 is EVAP Canister purge control valve/soenoid valve circuit!
Thread
Thread Starter
Forum
Replies
Last Post
jmlee44
4th Generation Maxima (1995-1999)
8
Oct 2, 2022 02:13 PM
tarun900
4th Generation Maxima (1995-1999)
19
Dec 20, 2021 06:57 PM
JoshG
4th Generation Maxima (1995-1999)
51
Sep 21, 2015 10:41 PM
pears
5th Generation Maxima (2000-2003)
15
Sep 18, 2015 05:25 AM



