Multimeter knock sensor tested no reading at all?
Thread Starter
Banned
Joined: May 2013
Posts: 253
From: south east conn.
Multimeter knock sensor tested no reading at all?
Ive been throwing the ks code and plan on changing it soon, but out of curiousity has anyone tested resistance with a multimeter and got no reading at all?.....im starting to think im not doin it right...i thought id get something....im checking it at the end of the ks harness!
thanks!
"Listen To Metal"
thanks!
"Listen To Metal"
When I replaced my knock sensor, I checked the ohms on the new one, which I bought at Nissan. It measured 560K ohms (or .56 meg ohms).
If the plastic housing on the knock sensor is cracked, you may very well be getting an open (infinity) reading. I took the old one apart and was surprised that the connection to the core of the sensor is just pressed against the core, held tight by the plastic case. So if the case cracks, which seems to happen a lot, it's new sensor time.
If the plastic housing on the knock sensor is cracked, you may very well be getting an open (infinity) reading. I took the old one apart and was surprised that the connection to the core of the sensor is just pressed against the core, held tight by the plastic case. So if the case cracks, which seems to happen a lot, it's new sensor time.
Thread
Thread Starter
Forum
Replies
Last Post
Maxima30
5th Generation Maxima (2000-2003)
2
Sep 7, 2015 06:13 PM
sdotcarter
6th Generation Maxima (2004-2008)
2
Sep 2, 2015 09:53 PM