Heya Max Fam! I just installed the Stillen rear sway bar on my 2010 SV along with some Michelin Primacy 4x4. I noticed the trac. control light and swerving symbol lights up after driving for like 30 mins. I am getting alignment on the 1st do you think that is the problem? Also does the Stillen rear sway bar use different bushings? The instructions just said use stock hardware I put some new brackets and bushings on the bar.

 

I really dont know about your stillen but make sure your brake fluid is topped off. Low fluid level is perhaps the top reason by far for the traction control/abs lights.

 

No, the Stillen rear bar is the same OD as the factory bar, so using your original hardware is fine.....it's a thicker wall tubing.

 

Thanks! After I got the alignment the light stopped coming on so I guess it knew it was out of spec.