Long embarrassing story short, while removing UIM I broke some of the plastic on the tan part of the IACV. No junkyards around have maximas and I'd like to save the $50 and salvage this. Before I go JB welding it back together I want to make sure I have all the connections aligned how they were and none are bent out of place.

so if someone could remove theirs to take a cpl good pictures at the right angles so I can use it as a guide, it's the tan piece held on by 3screws and I'd be extremely grateful



in the last pic the pin on the right is bent back a little bit I assume it's supposed to be the same as the others