Porting headers...
Porting headers...
Worth it? I'll never have a better oppertunity to do this than now: before I put the new engine in the car.
Any ideas on cost? Is this something that could be a DIY project?
Any ideas on cost? Is this something that could be a DIY project?
Originally posted by 3000GT
you can easily do it yourself- i did it but i only port matched the flanges--keep in mind that a completly open exhaust raises hp but lowers torque--youll want to have tq especially with a cent. s/c
you can easily do it yourself- i did it but i only port matched the flanges--keep in mind that a completly open exhaust raises hp but lowers torque--youll want to have tq especially with a cent. s/c
Also...I realize that there may not be a lot in gains, as Don In Texas has already proven...however, I can't imagine it would hurt. Loosing a _little_ torque wouldn't necessarly be a bad thing.
Originally posted by Y2KevSE
But you are F/I while he was N/A. There will be a gain... how much, I don't know.
But you are F/I while he was N/A. There will be a gain... how much, I don't know.
So...how do I do it!
I guess I'll just figure something out.
Thread
Thread Starter
Forum
Replies
Last Post
Omar Abdurrahman Siddiqi
5th Generation Maxima (2000-2003)
33
Aug 26, 2016 05:18 PM
Car Addict
Audio/Video/Electronics
0
Aug 27, 2015 09:01 AM
MaximaDrvr
7th Generation Maxima (2009-2015)
16
Aug 19, 2015 08:20 PM
