Colorado Turbo Kits
#3
Originally Posted by Tmeyers
Anyone from Colorado have a Turbo Kit in their 4th Gen ?
I'm looking into Turbo's and want to know who can do the
complete install and how much.
Thx, TMeyers-Colorado
I'm looking into Turbo's and want to know who can do the
complete install and how much.
Thx, TMeyers-Colorado
#6
Guest
Posts: n/a
PFI and Nigel are in Fort Collins. Go to www.pfispeed.com . They are the "main" producer of turbo kits for our car.......
#9
Dafro - http://forums.maxima.org/member.php?u=9423
Nigel - http://forums.maxima.org/member.php?u=10724
They are both in Ft. Collins. Nigel is in and out of the country so it may be hard to get in touch with him.
Nigel and DafHO have dynoed, I don't remember the numbers right off.
Nigel - 5-speed
DafHO - Aut-HO
Nigel - http://forums.maxima.org/member.php?u=10724
They are both in Ft. Collins. Nigel is in and out of the country so it may be hard to get in touch with him.
Nigel and DafHO have dynoed, I don't remember the numbers right off.
Nigel - 5-speed
DafHO - Aut-HO
#15
Originally Posted by Tmeyers
I could install it myself...but the tunning and dyno would have to
be done at the shop
be done at the shop
Yes, it can be done, I even managed to do it. Bill at PFI is a good guy and assured me some things have been changed so hopefully it's a lot better and more of a "bolt-on, weekend thing" for you.
If you are going to do it, it's possible to do with just hand tools but you'd be well served by having the following;
a compressor with an impact wrench and ratchet, metric deep sockets, power screwdriver, Dremel and metric box/open-end wrenches, torque wrench, PB Blaster, 1/2" NPT tap, 13/16" drill bit, (last 2 are only if you're tapping the valve cover for oil return) assortment of pliers, and a Sawzall (or other reciprocating saw to cut bumper for IC). There might be other stuff but that's what comes to mind at this point.
For elecronics/gauges, you'll need; various sizes of vaccuum line, gauges, multimeter, crimps, extension wires to splice MAF wiring, soldering iron w/ solder, electrical tape, wire taps, etc.
Tuning issues would have to be addressed locally.
Thread
Thread Starter
Forum
Replies
Last Post
litch
4th Generation Maxima (1995-1999)
123
01-04-2024 07:01 PM
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
Pied
4th Generation Maxima (1995-1999)
0
09-26-2015 03:29 PM