Is injector cleaning/blueprinting worth it?
Is injector cleaning/blueprinting worth it?
Just got a set of used 370cc injectors.
I was going to have them cleaned here:
http://www.cruzinperformance.com/fuelinj.html
However, I just emailed him and he's got too many top-feed injectors to do to convert his equiptment to handle side-feeds. It would have cost $11/each there.
RC wants in the ballpark of $25/each, making it a much more expensive process, and a little more than I wanted to spend on this.
Worth it?
I was going to have them cleaned here:
http://www.cruzinperformance.com/fuelinj.html
However, I just emailed him and he's got too many top-feed injectors to do to convert his equiptment to handle side-feeds. It would have cost $11/each there.
RC wants in the ballpark of $25/each, making it a much more expensive process, and a little more than I wanted to spend on this.
Worth it?
not many places have side feed injector set up.
they can still clean them and etc..but the flow/blueprint part you're not going to get unless you go RC...but at the point might as well pony for a new set.
they can still clean them and etc..but the flow/blueprint part you're not going to get unless you go RC...but at the point might as well pony for a new set.
Originally Posted by DanNY
not many places have side feed injector set up.
they can still clean them and etc..but the flow/blueprint part you're not going to get unless you go RC...but at the point might as well pony for a new set.
they can still clean them and etc..but the flow/blueprint part you're not going to get unless you go RC...but at the point might as well pony for a new set.
Thread
Thread Starter
Forum
Replies
Last Post
jmlee44
4th Generation Maxima (1995-1999)
8
Oct 2, 2022 02:13 PM
Forge277
1st & 2nd Generation Maxima (1981-1984 and 1985-1988)
12
Jun 13, 2016 09:26 PM