"Re" Install Pics
#1
"Re" Install Pics
I took everything out almost two months ago to get powdercoated and I have been steadily collecting parts to run a high boost setup. I finally took pics and am getting everything working over the weekend. Mods are:
4:1 disk on vortech fmu
3.33 pulley (until i tune properly and then the 2.87 goes in)
custom air to water aftercooler
replumbing the fuel system-this has only been done on the 3rd gens (afaik) and i am going to try this on the vq (thanks to scott)
slight polish of the blower (used scotch brite on the satin finish-thanks Stephen Max)
reclocking the blower (thanks broaner)
zeitronix wideband/boost/egt (thanks to royal_T for help on the group deal)
cyberdyne fuel pressure gauge
aem fpr(already installed)
walbro 255 HP (already installed)
here is everything that is powdercoated
here is the bov
this is a close-up pic of the air->water after cooler (heat exchanger not pictured)
4:1 disk on vortech fmu
3.33 pulley (until i tune properly and then the 2.87 goes in)
custom air to water aftercooler
replumbing the fuel system-this has only been done on the 3rd gens (afaik) and i am going to try this on the vq (thanks to scott)
slight polish of the blower (used scotch brite on the satin finish-thanks Stephen Max)
reclocking the blower (thanks broaner)
zeitronix wideband/boost/egt (thanks to royal_T for help on the group deal)
cyberdyne fuel pressure gauge
aem fpr(already installed)
walbro 255 HP (already installed)
here is everything that is powdercoated
here is the bov
this is a close-up pic of the air->water after cooler (heat exchanger not pictured)
#2
here is the great work on the pintle caps, etc that www.witchhunter.com did
#9
I'm sending my injectors to the same place to have them serviced. Great prices, I assume you are happy with the job they did?
I've been scrounging around for an A-W cooler lately myself, but those things are sort of hard to come by, at least for a cheap @ss like me. Where are you mounting it?
Everything looks very nice!
I've been scrounging around for an A-W cooler lately myself, but those things are sort of hard to come by, at least for a cheap @ss like me. Where are you mounting it?
Everything looks very nice!
Thread
Thread Starter
Forum
Replies
Last Post
MaxLife17
8th Generation Maxima (2016-)
43
06-27-2019 01:37 PM
MikesChevelle
5th Generation Maxima (2000-2003)
4
08-06-2015 11:36 AM