why do injectors wait to leak
Thread Starter
Joined: Mar 2004
Posts: 3,385
From: oburg S.C.
why do injectors wait to leak
ok well got my car back running ok for now intill dyno. Since the motor rebuild,adding, cams ,370cc injectors, and fpr. Ok well I drove it up and down my road for a while and did not get to far off from home. well every thing went fine. So i get enough ***** to ride accross town to where all my friends was. ok shut the car off and went to crank it back up to leave and boom it was skipping realy bad. SO i check the fuel pressure and show enough it drops on the gauge fast. But I wonder why dont they leak at first and why it a takes a while for them to do so. I went through this when I put my 259cc injectors in a while back.
dunno man but i sure does suck... ive had it happen to me and my buddy a few times... Stupid Side feed injectors... i would recomend once there fixed before you put the manifold back on preasurise the Fuel system and if they dont leak Wiggle all of them inthe fuel rail while under pressure, just to make sure the lower Injector seals are seated correctly. thats basically the only way ive found to try and be sure there right before you put it all back togeather.
Good luck.
Jeremy
Good luck.
Jeremy
Thread Starter
Joined: Mar 2004
Posts: 3,385
From: oburg S.C.
ok well I thought I had it fixed and boom I drove it around town, got it running a little smoother. Like after about an hour after driving it, their goes it again another injector leaking
Thread
Thread Starter
Forum
Replies
Last Post
jmlee44
4th Generation Maxima (1995-1999)
8
Oct 2, 2022 02:13 PM




