i would have measured it myself but i didnt consider this problem until after i got back home from where my car is at. i only intend on going back to the location (2 hours from civilization) one last time to finish up my fabrication and i would really appreciate if someone could help me out on the size of the alternator belt when the ac compressor is removed (for oil drainage purposes).

 

i'm running the v1 sc with the 3.33" wheel and bypassed the compressor with a napa belt#060685 ...hope this helps,it works for me

 

thanks a lot, all i need now are the banjo bolts for two water lines on one of my turbos and i will be good to go!

 

i went to napa and belt 060685 was about 3 times too long... thanks though, question still applies.

 

Yea,i didn't realize you had a turbo at the time,i was just telling you what worked for my set-up
Good luck bud

 

oh ok, so that belt you reccomended is for crank+alternator+supercharger pullies, i see now why it was so long.