UDP and Unothordox timing mark misprint
#1
UDP and Unothordox timing mark misprint
You have a few choices:
1) If the marks are equally spaced, you can just continue the marks on the pulley until you get to where the stock ones are supposed to be.
2) Even though the two pullies are two different sizes (stock/performance), you they are still 360 degrees. If you take the udp and start dividing up the pulley into 360 / 180 / 90 / 45 / etc.. degree increments, you should eventually get to where the stock ones are.
1) If the marks are equally spaced, you can just continue the marks on the pulley until you get to where the stock ones are supposed to be.
2) Even though the two pullies are two different sizes (stock/performance), you they are still 360 degrees. If you take the udp and start dividing up the pulley into 360 / 180 / 90 / 45 / etc.. degree increments, you should eventually get to where the stock ones are.
Thread
Thread Starter
Forum
Replies
Last Post
kjlouis
4th Generation Maxima (1995-1999)
12
10-03-2015 05:29 AM
trungg86
4th Generation Maxima (1995-1999)
7
09-04-2015 04:58 AM