Custom made air intake adaptors?
#2
Guest
Posts: n/a
u can make one out of the existing parts. just drill/knock off the rivits holding the brass 'horn' to the bottom side of the stock airbox and cut off the flare and there ya go..a 3" flange for a cone filter.
theres a previous post about this not too long ago...went into more detail i think..
theres a previous post about this not too long ago...went into more detail i think..
Thread
Thread Starter
Forum
Replies
Last Post
-ReLLiK-
4th Generation Classifieds (1995-1999)
0
09-08-2015 12:02 PM