custom trunk pics?
#1
custom trunk pics?
I'm redoing my stereo for the summer, I want my subs and amp to take up less space, just wondering if anyone had pics of their customs setups? any pics would be helpful and much appreciated
thanks
thanks
#3
for larger versions of those pics and quite a few more check out my site
http://maxima.cardomain.com/member_p...=155145&page=5
i'm actually redesigning it again
http://maxima.cardomain.com/member_p...=155145&page=5
i'm actually redesigning it again
#4
Originally posted by Chris91SE
for larger versions of those pics and quite a few more check out my site
http://maxima.cardomain.com/member_p...=155145&page=5
i'm actually redesigning it again
for larger versions of those pics and quite a few more check out my site
http://maxima.cardomain.com/member_p...=155145&page=5
i'm actually redesigning it again
#5
Originally posted by maxinmaxima
do you have any problems with moisture in the cap or amp having them in the wheel well?
do you have any problems with moisture in the cap or amp having them in the wheel well?
the amp is actually mouted above the box if you look closely at some of the later pics...
#6
Got Beat?
For now i have two 12s in a custom box and then covered with a custom panel so that the haters won't be "all up in my ****" when i need to get something out of the trunk. Its made of wood with the area in front of the speakers cut out and covered with carpet.
#9
Originally posted by Chris91SE
man i'd go nuts w/o the trunk space hence my setup... looks nice though
man i'd go nuts w/o the trunk space hence my setup... looks nice though
Thanks
#10
Originally posted by 89sks
Anyone ever mount a 10 or 12 sub in a box that had the same width and height of the panel mounted to the back of the seat with a corresponding depth to acheive the correct amount of volume while having the entire enclosure bolted to the rear seat crossmembers with sub facing and firing through hole where the armrest folds down? This was an idea I had as I wanted to maintain as much trunk space as possible. Not sure if my run on sentence made any sense though.
Thanks
Anyone ever mount a 10 or 12 sub in a box that had the same width and height of the panel mounted to the back of the seat with a corresponding depth to acheive the correct amount of volume while having the entire enclosure bolted to the rear seat crossmembers with sub facing and firing through hole where the armrest folds down? This was an idea I had as I wanted to maintain as much trunk space as possible. Not sure if my run on sentence made any sense though.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
REDinLV
7th Generation Maxima (2009-2015)
5
08-15-2024 12:30 AM
BPuff57
Advanced Suspension, Chassis, and Braking
33
04-16-2020 05:15 AM
bigfrank
4th Generation Maxima (1995-1999)
2
10-01-2015 12:51 PM