Thread pitch on O2 sensor
#1
Thread pitch on O2 sensor
I am rebuilding my exhaust as it fell of due to extreme rust. The threads on my old o2 sensor are so rusted/fubared that I can’t tell what the pitch is on the threads. I am building my new exhaust tomorrow and need to weld a nut to the pipe but I don’t know what size nut to use as my new o2 sensor wont be here for a few more days. If any of you could check this for me I would be most great full.
Thanks a lot.
Thanks a lot.
#3
Originally Posted by SocomMaxima
is your o2 sesor to rusted to get the treads from? if so, you might want to buy a new one. Then you can just check the threads on it.
Originally Posted by pinkfloyd
The threads on my old o2 sensor are so rusted/fubared that I can’t tell what the pitch is on the threads
Originally Posted by pinkfloyd
my new o2 sensor wont be here for a few more days
#4
arg, i gusse i will have to wait for my new sensore. My parents are giveing me crap and telling me i should bring into the shop. Anyway if you any of you could help me speed up my little project that would be great.
thanks
thanks
#6
ok i did it and it sounds like compleat ****. I am going to try something different with a different muffler in a few days. wish me luck.
as fare as putting on the nut to the exuast for the 02 sensor it worked great and the o2 sensor stays there fine.
as fare as putting on the nut to the exuast for the 02 sensor it worked great and the o2 sensor stays there fine.
Thread
Thread Starter
Forum
Replies
Last Post