joe4

i got a new alarm with a roll up module. i just need to to know whether i need to tap the wires at the main window switch or go to each individual door switch for a 4 window roll up. and after you all tell me that what are the wire colors. the alarm is already in just want to finalize the window roll up.

internetautomar

iTrader: (30)

go to the main switch, all the windows have wires there.

joe4

cool and would it be wise to just mount the module in the door panel or do i need leave it in the dash

internetautomar

iTrader: (30)

personally I'd leave it in the dash.

«§»Craig B«§»

iTrader: (5)

I dont think that'll work

At the driver's side switch, there are just signal wires to the other windows. It will be 12V for roll down and 5V for roll up on the wire going to each window.
I think you'll need to run wires to each door switch where you can get the two main wires for each window motor. They are thick, blue wires with a stripe on them (I think one is white and one is red or something like that).

joe4

well i got everything hooked to the alarm now i just need the module to the windows. i see that i need to run wires to each door thats easy buy i need the wiring diagram for the windows so ill know whats wat. come on i know someone knows something(craig) hehe

«§»Craig B«§»

iTrader: (5)

At each motor, there is a blue/black wire and a blue/red wire. Power one and ground the other. The window will go one way, switch the power and ground and it'll go the other way. That's how you can figure out which wire is which. You should be able to hook it up now

joe4

what are the exact wire colors for each window so i can find out what to tap

joe4

sorry about the repst the board wasnt updating on my computer. i dont know what was happening

tobe2be

iTrader: (1)

i got the window roll down module if you want one i bought it but got fustrated because i would need 2 to make the windows roll up and down with the control. let me know