Hey, I just got a set of sparco torino's and I am struggling to figure out how I am going to mount them. Sparco says they only have brackets for 90-93 and 96-99. WHY DID THEY LEAVE OUT 94 and 95? But the weird thing is corbeau did the same. So I wanted to know if they really are the same or if they are different. I will take pictures later today. Thanks.

-Larry

 

im sure i herd someone say the 4gen seats bolt right up...to 3rd gen's
-all the 3rd gen seats seem to be the same. but then again... the rear calipers seem the same too... but there not.

any pics of the seats?

 

i wonder similar questions about this, why is my chiltons for 85-92?? when 3rd gen is 89-94
i mean cant be a vg or ve thing
know what i mean verne?

 

Ok Here are some pictures:


These are the new seats that I got, I wanted it to somewhat match.


This is where the stock seat should be


this is another angle. The right side and the left of the mount's are not the same height.


The bottom of the new seat

 

Does nobody know? HELP!

 

It's too bad we have the same year. Otherwise I could just drive over and we could compare. The seats look really good, I think they'll match nicely. It was cool seeing you on the freeway today. Sorry you had to see my car so dirty :P

 

Your car sounded good. I love seeing people I know on the freeway

 

well, that looks just like the mount for my 93, so I can't imagine they are off by much

 

Good, at least it looks like it. I will order the brackets. I can't belive they are like 150 for each seat!

 

yeah they are the same. not sure why they would label them the way they did...year wise unless they really didnt pay attention or something.

 

maybe they got their information from a chiltons manual

 

I've always wandered about the cable that goes under the driver's seat. What is it's purpose since I don't have power seats?

 

its so you can have power seats if you want them.

They pre wire the cars for power seats (at least on USDM cars they do) and just plug off the lines into a dummy plug in the seat if you dont have power.

Neither of my SEs had power but I put my power seats from my gxe in them and they plugged right up and worked.

 

The cable is both for the power and also for the seatbelt buckle sensor.

The brackets for 89-94 are the same. And 95-99 should be the same.

Brian

 

a little off topic, but can anyone confirm that 4th gen seats fit in 3rd gens?

 

http://forums.maxima.org/showthread....t=4th+gen+seat