Anyone have problems with their power window switches? I can roll all the windows down from my buttons on the driver side but can't roll them back up unless i reach over to the window and roll them up with their own switch. Any comments or suggestions? Thanks.

 

you need a new switch, which is called the master switch, its about about a $100.00 or more at the dealer.

 

The system is all computerized: each door sends signal request to driver door PCB. That uses ctrl box to send current for motors at requested direction. When door PCB's are overloaded, ctrl signal drowns and 'remote' dose not work.

check http://www.cardomain.com/memberpage/748507/13

 

usually after rain my drivers side rear window rolls down about 3 inches when I start the car.

 

Heard similar stories: The moisture on the door PCB may cause ctrl signals to be sent. Open and take a look if water may seep on iti, or connectors, wiring...

Anyways, as the system relies on small electronics signals, very small moist -or- oxidation issues can make it act weird.

 

mine was the opposits. mine would roll them up but not down and now it wont work any but the drivers. Can i get a used one

 

Cool HUH? What is cool? Being in internet when u used diapers? Grow up!