move carpet for power wire
#3
open your cars doors and there will be some little door seals, take those of and u can just shove the wire under there, u will also need to take of the coloums between each door, when u get to your back seats just shuve the wire under with a coat hanger or somthing like that, u will probly also need to take off your front kick pannel
#4
take your seat out and it will be a whole lot easier, when i ran ran my wires i took them out and and the removed the molding by the doors and the carpet just lifted up. its easier than it sounds and it looks way better than visible wires
#6
Originally Posted by AscendantMax
try running it along the door sills. that's how i ran my power wire.
#7
Originally Posted by NYC 92 GXEr
On the passenger side, I ran the RCAs so that it would be far enough from the power to not cause any interference.
#8
Supporting Maxima.org Member
Thread Starter
iTrader: (33)
Join Date: Jun 2004
Location: Plano, TX
Posts: 1,148
well i got two 4 gauge already running under the carpet and im about to add a distribution block with two 0/4 gauge input and 4 4/8 gauge output i'm adding a 4 channel amp to my 2 mono amps and i will put the distribution block in my center console area. Just a little fyi. I'll let you know how things go if it all works out I should be done by end of 4th july weekend
#14
HOWTO run the power wire through the firewall:
DRILL, DRILL, DRILL! This is the best option as it's quick and you can prevent any chance of rust by painting over the hole. Engine noise into the cabin isn't noticeable, esp since you'll be making use of those amps if you're running a power wire to the truk
Just drill a hole on the driver's side and run the power cable in the driver's side door sills and run it all the way to the trunk (no need to even take off the top cushion but you will need to take out the bottom cushion which is just a push up).
DRILL, DRILL, DRILL! This is the best option as it's quick and you can prevent any chance of rust by painting over the hole. Engine noise into the cabin isn't noticeable, esp since you'll be making use of those amps if you're running a power wire to the truk
Just drill a hole on the driver's side and run the power cable in the driver's side door sills and run it all the way to the trunk (no need to even take off the top cushion but you will need to take out the bottom cushion which is just a push up).
Thread
Thread Starter
Forum
Replies
Last Post
The Frye
7th Generation Maxima (2009-2015)
6
09-02-2021 11:03 AM
sdotcarter
6th Generation Maxima (2004-2008)
2
09-02-2015 09:53 PM