Results from my dyno at the United Nissan Meet
#1
The first run didn't go so well, I have no idea what happened the car just lost all power, I think it's a fuel issue. The second run was better, I got a max of 127 hp and 150 torque. There was a little deatonation up top so I need to lower the timing a bit.
I will be prototyping Warp Speed's new non-mandrel bent Y pipe against the mandrel bent one to see what the differences are, after looking at both I don't think there will be much if any.
I will be prototyping Warp Speed's new non-mandrel bent Y pipe against the mandrel bent one to see what the differences are, after looking at both I don't think there will be much if any.
#5
HoJo-
Let me know when you're coming back to KC to dyno. I think I will dyno my UDP when you dyno your Y-pipe.
BTW, what is the diameter of your intake pipe? I have a friend who bought my HKS intake off my Max, but he ended up selling his Max shortly after and I believe he has the HKS intake sitting in his garage. I'm sure he'd sell it cheap. It is the typical honeycomb mushroom shaped intake with a green filter and velocity stack.
Dave
Let me know when you're coming back to KC to dyno. I think I will dyno my UDP when you dyno your Y-pipe.
BTW, what is the diameter of your intake pipe? I have a friend who bought my HKS intake off my Max, but he ended up selling his Max shortly after and I believe he has the HKS intake sitting in his garage. I'm sure he'd sell it cheap. It is the typical honeycomb mushroom shaped intake with a green filter and velocity stack.
Dave
Thread
Thread Starter
Forum
Replies
Last Post
dvcamp
6th Generation Maxima (2004-2008)
7
09-18-2015 10:17 AM
Justin Kroll
5th Generation Maxima (2000-2003)
7
09-02-2015 11:06 AM