muffler install questions
#1
I was going to take my muffler to the shop to get it welded on tomarrow, and my friend brought up something. He says that I can get clamps or something and clamp my exhaust muffler to the existing exhaust piping since my install looks like htis:
muffler -> 2.5" to stock piping -> stock piping
I just clamp where where ther are "->"s...will this work? or do ineed to weld?
muffler -> 2.5" to stock piping -> stock piping
I just clamp where where ther are "->"s...will this work? or do ineed to weld?
#3
Re: with exhaust system,
Originally posted by bigjay
anything is possable! if the shop can't do it, run don't walk out of there,they are obviousely suspect. you can make a better exhaust than they ever could with coke cans and duct tape
anything is possable! if the shop can't do it, run don't walk out of there,they are obviousely suspect. you can make a better exhaust than they ever could with coke cans and duct tape
#4
Re: with exhaust system,
Originally posted by bigjay
anything is possable! if the shop can't do it, run don't walk out of there,they are obviousely suspect. you can make a better exhaust than they ever could with coke cans and duct tape
anything is possable! if the shop can't do it, run don't walk out of there,they are obviousely suspect. you can make a better exhaust than they ever could with coke cans and duct tape
#5
Originally posted by ngthing
I was going to take my muffler to the shop to get it welded on tomarrow, and my friend brought up something. He says that I can get clamps or something and clamp my exhaust muffler to the existing exhaust piping since my install looks like htis:
muffler -> 2.5" to stock piping -> stock piping
I just clamp where where ther are "->"s...will this work? or do ineed to weld?
I was going to take my muffler to the shop to get it welded on tomarrow, and my friend brought up something. He says that I can get clamps or something and clamp my exhaust muffler to the existing exhaust piping since my install looks like htis:
muffler -> 2.5" to stock piping -> stock piping
I just clamp where where ther are "->"s...will this work? or do ineed to weld?
Thread
Thread Starter
Forum
Replies
Last Post