Quick Control Arm Quest.
05-31-2006, 12:28 PM
#1
Quick Control Arm Quest.
I'm in the middle of swaping out C-Arms, BJ, Tie Ends and was wondering if I should use any lube (ie grease, light oil) when sliding on the new control arm (over the 27mm bolt)?
Also, noticed my rack boot had a slight tear - I found one at napa near me - is it a PIA to replace? Seems simple enough, just a hard reach; any experience?
Also, noticed my rack boot had a slight tear - I found one at napa near me - is it a PIA to replace? Seems simple enough, just a hard reach; any experience?
Thread
Thread Starter
Forum
Replies
Last Post
tseng1023
5th Generation Classifieds (2000-2003)
3
10-15-2015 08:30 AM
DC_Juggernaut
7th Generation Maxima (2009-2015)
4
09-28-2015 04:07 PM