Heater Valve
10-15-2006, 07:41 PM
#1
Junior Member
Thread Starter
Join Date: May 2006
Posts: 27
Heater Valve
Hey all
I have a fairly simply question
when my brother blew my old motor it melted a heatercore barb and i guess screwed up my heater valve. i repaired the barb but i need to wait for the junkyard to open again so i can strip a new valve. Can i run my heater without a Heater valve ? Right now i have the 2 heaterlines jointed with a connector but its getting so cold outside i just need heat in the morning.
Oh and can anybody show me a diagram of this entire setup?
I used a Jb weld type epoxy on the barb, how many PSI do coolant lines run?
thanks alot.
I have a fairly simply question
when my brother blew my old motor it melted a heatercore barb and i guess screwed up my heater valve. i repaired the barb but i need to wait for the junkyard to open again so i can strip a new valve. Can i run my heater without a Heater valve ? Right now i have the 2 heaterlines jointed with a connector but its getting so cold outside i just need heat in the morning.
Oh and can anybody show me a diagram of this entire setup?
I used a Jb weld type epoxy on the barb, how many PSI do coolant lines run?
thanks alot.
Thread
Thread Starter
Forum
Replies
Last Post
TKHanson
5th Generation Maxima (2000-2003)
6
11-24-2018 01:39 AM
tseng1023
5th Generation Classifieds (2000-2003)
3
10-15-2015 08:30 AM
hayne
6th Generation Maxima (2004-2008)
2
10-05-2015 11:53 AM