TWINTRBO

Where can I pass the alarm siren cable through the firewall? I dont want to drill if possible. Thanks.

goon9

iTrader: (13)

Same place all the other wires go through.

Take out your driver wheel, remove splash gaurd. Look up in the fender and you'll see alot of wires going through a rubber piece. Stick a long screw driver through it and feed the needed wire back through.

Matt93SE

iTrader: (44)

VEvolution

Maybe tape the wire to a long antenna and poke ur way through that rubber from underneath the dash?

Matt93SE

iTrader: (44)

if it's as small as you say it is, you can also use the hood release cable grommet. it's much thinner and easier to puncture. I've used it with up to 4awg wire before..

TWINTRBO

cool, thanks guys. I'll get out there tomorrow and take care of the siren and then I'll be done with this alarm install finally!

goon9

iTrader: (13)

I wish I was smart enough to wire up an alarm. Hope my doesn't break so Craige doesn't need to fly down here to fix it.

VEvolution

It's really easy.. I practiced like on 3 cars at work with a bit of help, and I pretty much got it down tight. Hardest part is finding the correct colors that are going to the ignition, but most alarms have a website that tells you which is which for each car.

Matt93SE

iTrader: (44)

maxima wiring stuff...

http://blehmco.com/faq/wiring_info/