tapping exhaust gas sensor for air/fuel meter?
#3
Originally posted by HoJo
Are you talking about the O2 sensor? It depends on the AFM. Some will run off of the stock O2 sensor, but most AFM's need a wide band O2 sensor. You would need to put another fitting on the Y-pipe for it.
Are you talking about the O2 sensor? It depends on the AFM. Some will run off of the stock O2 sensor, but most AFM's need a wide band O2 sensor. You would need to put another fitting on the Y-pipe for it.
#4
Originally posted by ngthing
I don't know if the EG sensor is the same as the O2 sensor, the EG sensor is located in the engine bay. I'm running a AF meter off whateverI tap.
I don't know if the EG sensor is the same as the O2 sensor, the EG sensor is located in the engine bay. I'm running a AF meter off whateverI tap.
#5
Originally posted by DA-MAX
just get under your car and tap the wire directly from the sensor...my mechanic did mine for free when he changed my brakes. I think its the white wire, but I'm not 100%!
just get under your car and tap the wire directly from the sensor...my mechanic did mine for free when he changed my brakes. I think its the white wire, but I'm not 100%!
anybody have any otheri nput on the EG sensor?
#6
Originally posted by ngthing
would it be too much of meto ask you go down and check?
anybody have any otheri nput on the EG sensor?
would it be too much of meto ask you go down and check?
anybody have any otheri nput on the EG sensor?
Thread
Thread Starter
Forum
Replies
Last Post
sdotcarter
6th Generation Maxima (2004-2008)
2
09-02-2015 09:53 PM