davis4004

Well, I'm trying to remove the plugs that plug into the injectors so I can get the main harness out of the way. I know that there is that metal clip, but I can't get it to slide out. Any help would be greatly appreciated. Thanks!

Jeff92se

iTrader: (82)

Hmm VG? If there is a small metal square clip that holds them in, you have to use a reall small screwdriver or pick.

You gently pry one end of the clip at the end and push it out. At the same time, pull the connector out a little on that side. This should prevent the clip of "snapping" back in. then do the same on the other side. The connector should come right out. Becarefull not to pry too much or you might break the clip holder on the back of the connector.

wiggumz

where is the clip located on the connector? i cant seem to find it anywhere so i can get the connector off.

davis4005

It's on the bottom part of the connector, is shiny and goes around the whole bottom, you can't miss it.