THis is all i have left for manual parts

95 ECU $100 shipped SOLD

Stock shifter $40 shipped

Shifter Bushing $30 shipped

Slave Cylinder $25 shipped

Stock Rubber Lines and bleeder valve from the strut tower (somebody stole the hard lines from me) $15 shipped

I have axles as well.

2 transmissions in need of rebuilds (differential bearings)

I have the wiring harnesses as well.

miles and condition on the slave cylinder? let me know. thanks.

Good condition. 78,000

Everything still available.

so how about those transmissions? 5 speed i assume? and how many miles...

Yes there 5 speed transmissions. One has 78,000 the other has 201,000.
I drove both cars. The one trans you couldn't get the shifter into 1st or 2nd. The other there was no 3rd

Everythings still available.

Anybody at all?

ill take the speed sensor out of either....

$25 shipped

full pm box

Cleared it out some.

^^^^^^^^^^^^^^

^^^^^^^^^^^^^^

^^^^^^^^^^^^^^^^^^^^^

Black 5 Speed shifter bezel?

THis is all i have left for manual parts

95 ECU $100 shipped

Stock shifter $40 shipped

Shifter Bushing $30 shipped

Slave Cylinder $25 shipped

Stock Rubber Lines and bleeder valve from the strut tower (somebody stole the hard lines from me) $15 shipped

I have axles as well.

2 transmissions in need of rebuilds (differential bearings)

I have the wiring harnesses as well.

so how much for the trans? Just wondering.

If not too expensive I'll buy and rebuilt it and sell it

Make me an offer on one or both.

^^^^^^^^^^^^^^^^^^

^^^^^^^^^^^^^^^^^^^^

will that ecu work on my 96 5spd..? do the options of the car need to match up also...ex(auto or manual climate, power seats)

thanks

Yes it will work on your 96 5spd. The ecu only controls engine functions. The 95 has less evap components then the 96 but it won't cause any problems.

do u have any good knock sensors on your hands also?

I should but will have to check. If i do and you buy the ecu $130 shipped for both.

sounds good....let me know if you find a sensor and ill send u the money friday.

^^^^^^^^^^^^^

lines for the clutch? and what kind of wiring harness

I only have the rubber line from the slave cylinder until it meets the hard line.
The harnesses were from cars that had manual transmissions. I will have to go thru and see what i have left.

im doing a 5 speed swap.... do i need any harness?

^^^^^^^^^^^

how much for both transmissions?

Where are you located?

Florida

I have had offers for $100 for each plus shipping. Shipping is the killer though.

do you have any 5 speed flywheels around if so let me know plz and how much shipped to 08629.

Sorry i don't