how to pop holes out for seat heats on a middle console that doesn't have holes?
how to pop holes out for seat heats on a middle console that doesn't have holes?
have 97 GXE and need to pop holes out, i see the linement for it but what would u recommend popping holes out? don't want to do just anything and have it look ugly....any suggestions?
Just remove the center console and pop them out from the inside. IIRC they can just pop out from the front if you pry them with a flat-head, but if you want to be very particular and careful (like I am 
), do the first.
-Cyrus
), do the first.-Cyrus
Supporting Maxima.org Member
Joined: Aug 2001
Posts: 1,362
I have a 98 Maxima and bought heated seats but have not installed the switches yet. I don't see any place where holes could be 'punched out'. Is this only in the 95-96 models? I was just going to cut the holes with a dremel.
Originally posted by Anachronism
I have a 98 Maxima and bought heated seats but have not installed the switches yet. I don't see any place where holes could be 'punched out'. Is this only in the 95-96 models? I was just going to cut the holes with a dremel.
I have a 98 Maxima and bought heated seats but have not installed the switches yet. I don't see any place where holes could be 'punched out'. Is this only in the 95-96 models? I was just going to cut the holes with a dremel.
-Cyrus
u guys must not be understanding me, I know how to pop out the seat heaters from my 95 console, i want to make holes on 97 console, if u look under every console, they have the lining for the seat heaters. I want to cut those holes without making it look nasty. What do you guys recommend for doing this?
Senior Member
Joined: May 2002
Posts: 196
I was wondering why you were saying you had a 97GXE when it says 95GLE in your sig! If your cutting I'd use a dremel tool and cut it about 1/4" to 1/2" too small. Then start filing away till the heated seat switch just fits.
Originally posted by JR_Anders
I was wondering why you were saying you had a 97GXE when it says 95GLE in your sig! If your cutting I'd use a dremel tool and cut it about 1/4" to 1/2" too small. Then start filing away till the heated seat switch just fits.
I was wondering why you were saying you had a 97GXE when it says 95GLE in your sig! If your cutting I'd use a dremel tool and cut it about 1/4" to 1/2" too small. Then start filing away till the heated seat switch just fits.
Originally posted by meccanoble
and what is a dremel tool?
oh, SIG TESTING!!
and what is a dremel tool?
oh, SIG TESTING!!
Originally posted by Vyrus
Looks good! I didn't know you got 5th Gen wheels mecc?
And you should probably take out the old pic. 
-Cyrus
Looks good! I didn't know you got 5th Gen wheels mecc?
And you should probably take out the old pic. -Cyrus
a dremel tool? how much does that cost? how about a box cutter? would that work?
Thread
Thread Starter
Forum
Replies
Last Post
