prob with JIM Wolf air intake/ambient temp snsr?
Thread Starter
Junior Member
Joined: Mar 2002
Posts: 28
prob with JIM Wolf air intake/ambient temp snsr?
I have the stillen pop charger air intake which was an easy install. I went to install a friends Jim Wolf pop intake and there is no port for the ambient air temp sensor? The instructions say to attach to bracket. Is that safe? has any one done this?
as I understand it the intake temp sensor measures the temperature of the air (duh!) as it first comes into the intake, and then compares it to another reading taken at the MAF. as long as the two numbers are pretty close together the ECU won't throw any codes.
so basically just zip-tie or attach it next to the cone and you should be okay.
so basically just zip-tie or attach it next to the cone and you should be okay.
Supporting Maxima.org Member
Joined: Oct 2000
Posts: 9,159
I can't find the pic right now, but I slid the sensor inside the intake.
Loose enough so that it wouldn't be sitting directly against the filter, but not so loose that it would bounce around everywhere.
Loose enough so that it wouldn't be sitting directly against the filter, but not so loose that it would bounce around everywhere.
Thread
Thread Starter
Forum
Replies
Last Post
tarun900
4th Generation Maxima (1995-1999)
19
Dec 20, 2021 06:57 PM