I just installed the Magnaflow Muffler and I noticed it hangs abit low. Maybe its just me? There is about a 2 finger gap between my bumper and the top of the exhaust. Is that too much? Is there a way I can lift the exhaust abit? I was thinking the exhaust was sagging because of the rubber hangers? Any ideas? Btw, the muffler sounds great. Not too loud, just a slight drone, very nice. I got the 14827 btw. Even with the Y-pipe on and the magnaflow, I was worried the car would be alot louder but to my suprise it is for the most part tame.

 

get some of those metal hose clamps with the screw that tightens it. put them over the rubber hangers and tighten it until the muffler lifts up. its kind of a ghetto solution but it works.

 

go back to the shop you had it welded on at..and tell them to do it again...explain you want it higher. I did this with mine, I wanted it tucked up nice and close to the bumper. they may have to shorten the hangers and raise the whole muffler, anyone that has any clue with a welding torch will know how to fix it