I removed the hamburger and M-A-X-I-M-A emblems and decided to put them back on. Im just not sure what Im supposed to use to put them back on. I went to AutoZone and all they had was a glue made by 3M for plastic emblems. Im not sure if it would be safe for the paint.

 

ask them what to use to put emblems on. i would use glue

 

3m double side tape- make shure its thin and gray in color not the white crap

 

Where could I find it?

 

autozone, pepboys, any car place, scotch also makes good stuff, just make shure its thin and a gray color. usually they come with a red plastic backing on it. its also called molding tape or mounting tape

 

"hamburger emblem"

took me 15 seconds to figure out what that meant, nice phrasing my friend !

 

yeah they come stock with that gray double sided tape, i wouldn't use anything else.

 

Use the grey 3m Tape, and place it flat along the back of the whole emblem, then use an x-acto knife to cut out the holes and sides of the lettering. And then to re-apply, its easier to run a long piece of tape through the front of the emblem and then make it so that the tape is the same length on each side of the trunk - that way the emblem should be centered.