Hello all:

Went out and picked up a Haynes manual. Time to replace the RTV on the upper oil pan. The Haynes has the torque sequence but not the torque specs for the bolts. Somebody have a Factory Service Manual? Any suggestions or points of interest to be aware of during this upper/lower oil pan "re-RTV" would be appreciated. Anyway, I really want to know the spec. before I start.

Thanks

 

The spec for the Steel oil pan is 6.4-7.5 N*m, or 4.7-5.5 Ft*Lb
For the aluminium pan the spec is 16-19 N*m or 12-14 Ft*Lb
Mike