HELP....DR mod is giving a CEL code
#1
HELP....DR mod is giving a CEL code
I just did the Drop Resistor mod and now I am getting a code on my ECU. It is 1205...."Line Pressure Solenoid Valve (Automatic Transmission)".
Is this a normal occurance or is there something wrong. If it is going to set off engine codes I dont like it too much.
Help appreciated....
AUS
Is this a normal occurance or is there something wrong. If it is going to set off engine codes I dont like it too much.
Help appreciated....
AUS
#2
Dont worry about the CEL, I had thought the same thing when I did it. all you have to do is reset the ECU. Just dont use it that much, not good for the tranny.
-Jon
EDIT: Did you disconnect it from the engine bay? or did you use a switch?
-Jon
EDIT: Did you disconnect it from the engine bay? or did you use a switch?
#3
I disconnected it to see what it was like....then installed the switch....then drove and got the CEL. It may be from the dissconnected drive...But I think I will continue with the install and put a switch inside too. That way I can also manually select it.
AUS
AUS
Thread
Thread Starter
Forum
Replies
Last Post
hez8813
5th Generation Maxima (2000-2003)
11
03-12-2020 12:06 AM
ballerchris510
4th Generation Maxima (1995-1999)
17
09-23-2015 08:46 PM
JoshG
4th Generation Maxima (1995-1999)
51
09-21-2015 10:41 PM