I was wondering if the JWT Pop Charger would be to heavy to put on an injen. I plan on attatching a MAF adapter backwards onto the pop charger and then claming one of those rubber pieces to the adapter as well as the intake pipe. I think that it will probably fall off just wondering if anyone has this setup.

 

As long as you secure it right and TIGHT it will stay on.

 

ya im gonna try to mount some sort of bracket to give it extra support but its almost worth it to just get a smaller and lighter filter cuz i doubt the pop charger is going to give much advantage over a regular filter anyway

 

double/triple hose clamp it if you don't feel safe about it

 

The injen has a piece that's welded on the second elbow (the one after the MAF) which attaches is bolted to the engine, so I don't think you'll have a problem. And if you are getting an injen, mount the MAF properly, that harness that plugs into it isn't that long and if you have to run it to the other side, the wires are gonna be super tight