installing autometer gauges
#1
installing autometer gauges
i got the oil press. water temp and volt gauges for my gauge pod. has anyone else installed these? and where did you install them? they are all electrical gauges. i was thinking of teeing the water temp in on the water neck where the dummy light sensor is. and the oil press on the oil pan where it looks like there is a sensor already. i am not sure as to what pipe thread is used at these locations i am thinking it is BSPT . I cant find any info anywhere on this. the volt gauge is not a problem just the other two.
#2
Originally Posted by ronin22357
i got the oil press. water temp and volt gauges for my gauge pod. has anyone else installed these? and where did you install them? they are all electrical gauges. i was thinking of teeing the water temp in on the water neck where the dummy light sensor is. and the oil press on the oil pan where it looks like there is a sensor already. i am not sure as to what pipe thread is used at these locations i am thinking it is BSPT . I cant find any info anywhere on this. the volt gauge is not a problem just the other two.
#3
You will need an HKS water temp mounting pipe for the water temp probe. It splices into your upper rad hose. They come in 38, 32, and 34 mm sizes, not sure which one we need. As for the volt guage, well anyone who doesnt know how to hook that up is a dumb@ss
Thread
Thread Starter
Forum
Replies
Last Post
97_GXE
4th Generation Maxima (1995-1999)
20
09-17-2015 08:12 PM
BrandonCause
4th Generation Maxima (1995-1999)
4
09-14-2015 10:41 PM