joesmith

Anyone else had a problem with a over torqued starter bolt (the large one)? I tried using a 1/2" ratchet with cheater bar and impact wrench and it is still stuck. The bolt has never been removed, so it was over torqued at the factory. Ideas on getting it loose?

A32Matt

wow...you couldn't get it off with the impact gun? spray that bish down with WD-40 or PB Blaster and let it sit for a couple minutes and have at it. Just keep spraying or get a stronger impact gun.

Igobuk

iTrader: (1)

You can also try heating it with a blow torch. You don't have to get it red hot or anything, just hot, like a minute or two. Once you get it hot, try the impact gun again.

sterlingmaxima

iTrader: (16)

yes the blow torch technique works best

Pappa Grande

Use a breaker bar and a pipe.

joesmith

I try it with a benzene torch, I hope that works. I'm going to try another impact wrench also. The wrench I was using was an older IR model, ~350 max torque.

2 Da Max

iTrader: (2)

i just used a long *** pipe on the breaker bar

ny96max

i had to use a craftsman 1/2" drive breaker bar and a 4ft long steal pipe with me and my brother pulling on it to get mine free...

goodluck!

Ant

amulla01

damn is it that hard to remove the fuking starter?

goodhead

iTrader: (4)

damn how u fit an impact in there? if you are using an ujoint+ extention make sure its a BLACK one not the chrome crap, or u must have a ****ty impact lol yeah 4' breaker bar did it for me