Today I installed a new bumper and a fog kit. I found the fog connections for the lamps and the new stalk and hooked them up. all lights work except the fogs. The fuses are all brand new. What else should I look for?

 

did you wire them in??? ground them??? not sure...just saying things

 

you defintely installed the stalk though, right? Because, that is the only way they will work with the factory harness down by the cut outs. Also, how exactly did you cut them out and make the holes look good?

I would check the harness and the functionality of the stalk.

 

i used a razor blade and kept cutting a little at a time carefully...loooked good but from a foot away u could see it was cut...

 

I bought a new bumper with fog cut outs. Bought the Nissan fog kit. It came with a new stalk. the car is pre wired. Tomorrow I will look at each fuse. I'm not sure which one is for the fog.

Thanks for the input

 

this might seem like a stupid question, but did you install the fog relay under the hood? they're definitely not going to work without that

 

Yes I did. It's funny but there was one already there. In the Fog kit there was a new one so I replaced the old with the new. I'm home for the rest of the afternoon so I'll pull each fuse just to make sure. i'll also see if I'm getting juice to the fogs.
thanks for the input!

 

The new relay was faulty. Went to the "stealership" and got a new one. Thanks everyone who sent there ideas. I love it when you nail something on and it stays!