after installin short ram intake? where does boost sensor go?
#1
after installin short ram intake? where does boost sensor go?
i have had my short ram intake on my car for a while now....one thing that i was curious about was where the BOOST sensor is suppose to be.....is it suppsoe to just hang in the engine compartment????
and what the boost sensor do?
and what the boost sensor do?
#4
dont sweat these guys man. your talking about the sensor that says boost on it in the front half of the stock intake right.....dont worry - try to get a little piece of metal ....fabricate one......good luck and not everyone is a dyck here on the org...
#7
Originally Posted by SiCkBLaCKMaX99
hahahaha lol you have to get a tornado fuel saver and electric supercharger from ebay connect it to the boost sensor and then you can put a boost gauge in your car
wtf...
#9
Actually I just had to replace mine because it was the cause of me failing inspection. (My CEL came on on the way to DMV... FAIL)
It is actually called a couple of different things. Boost sensor (marked on the part it's self), MAP sensor (Manifold Absolute Pressure sensor), or Absolute Pressure Sensor. I know this because the dealer called it one thing, parts stores called it a second, and the service manual called it a third.....
Just tuck it in somewhere or zip tie it to something that doesn't get hot.
It is actually called a couple of different things. Boost sensor (marked on the part it's self), MAP sensor (Manifold Absolute Pressure sensor), or Absolute Pressure Sensor. I know this because the dealer called it one thing, parts stores called it a second, and the service manual called it a third.....
Just tuck it in somewhere or zip tie it to something that doesn't get hot.
#11
Originally Posted by SiCkBLaCKMaX99
hahahaha lol you have to get a tornado fuel saver and electric supercharger from ebay connect it to the boost sensor and then you can put a boost gauge in your car
the boost sensor or absoulute pressure sensor measured atmospheric pressure.
just zip tie or tuck it away form moving oarts, and then you shold be fine. I made a littl ebracket to hold mine but if you don't it will okay.
#12
GUys i wanted to ask the same question. i wanted to install that EBAY poor man intake.. was curious about that sensor...so we can just zip tie it is it OK?..doesit have to be inside the cone filter to measure atmosphere pressure or temperature?? GUYS any positive feed back is appreciated....
Thread
Thread Starter
Forum
Replies
Last Post