Hey guys, i have a 96 gle and i m thinking about putting in stock fog light bracket thru my bumper area after i cut the piece out. What i have gather thru search is that the bracket should bolt up to my bumper beam with the holes for the screws already there. Is this the case??

Oh and any hints to how i could make a clean cut of my fog light opening? I m thinking using a dremel and then sand paper the edge, but would the dremel be too rough and roughen up my opening?

 

use a dremel that what my friend did when we did mine i have a 96 gle also. after you cut the holes out there will be holes already there for for the screws. so just line it up and screw it in

 

i used a dremel on mine. no sandpaper, no probs. they will bolt right up. plus, if you get the whole kit from nissan, it comes with a new turn signal switch. you will have the plugs for the foglights under there as well

before


after

 

here's pics of mine
[http://i32.photobucket.com/albums/d5...upclsejosh.jpg

 

cool, thnks for the info

 

i have a 99 gle, and the fog light holes have pieces running horizontally through the empty space. What's the best way to remove these?

 

same way, but you could probably just use a utility knife since your holes are more tucked away

 

If you need a set of brackets I have a pair laying around from a 99.

 

IS there a template i can get from nissan dealers to help me cut the fog opening?

 

Yea i wanna get some fogs for my 97....Is there a thread telling you how to wire them correctly

 

You have a PM.

 

Can anyone tell me how to change the bulbs???