When taking auto tranny pan off
#1
When taking auto tranny pan off
to clean the magnets do u have to take off the return line to get the tranny to force the fluid out of the TC ? or simply putting the pan back on and refilling with the ATF is fine ?
#2
When I last serviced my tranny I just cleaned the magnets and pan, installed new gasket and filter. Used the FSM for tightening sequence and used factory nissan ATF << I think it was 5 qts and at +/- $6 ea.>> I dont think you'll be able to get it at your local autozone etc, don't use merc/dex ATF, I read somewhere that the viscosity isn't correct for performance.
sam
sam
#3
Matic-D only is really preferred, viscosity and additives are the only difference. I've used regular Dexron III in all my autos, not an issue (short of me being on my 4th trans now, but had nothing to do with fluid type). According to some of my friends down at the Nissan dealer in TN (where I worked for a short bit) they've seen some problems in the Titans from not using Matic-J or Matic-K.
To the OP: Wouldn't worry about flushing out the TC, if you want to do a complete 'flush', follow the VQpower (or motorvate?) instructions with the cooler line.
To the OP: Wouldn't worry about flushing out the TC, if you want to do a complete 'flush', follow the VQpower (or motorvate?) instructions with the cooler line.
#5
Originally Posted by pmohr
Matic-D only is really preferred, viscosity and additives are the only difference. I've used regular Dexron III in all my autos, not an issue (short of me being on my 4th trans now, but had nothing to do with fluid type). According to some of my friends down at the Nissan dealer in TN (where I worked for a short bit) they've seen some problems in the Titans from not using Matic-J or Matic-K.
To the OP: Wouldn't worry about flushing out the TC, if you want to do a complete 'flush', follow the VQpower (or motorvate?) instructions with the cooler line.
To the OP: Wouldn't worry about flushing out the TC, if you want to do a complete 'flush', follow the VQpower (or motorvate?) instructions with the cooler line.
Thread
Thread Starter
Forum
Replies
Last Post
pktaske
6th Generation Classifieds (2004-2008)
1
05-06-2016 07:49 AM
kjlouis
4th Generation Maxima (1995-1999)
12
10-03-2015 05:29 AM
The Wizard
4th Generation Maxima (1995-1999)
24
10-01-2015 08:47 PM
pktaske
6th Generation Maxima (2004-2008)
0
09-04-2015 08:40 AM